SuperTie™ Coil Rod Series

Fiberglass Form Tie-System

Say goodbye to corrosion forever. Easier to use, saves time, and less expensive than traditional steel form ties. SuperTie™ patented fiberglass form tie-systems are used to secure concrete formwork during concrete placement and initial hydration, without the inherent limitations and rusting of previously popular steel form-tie systems.

• Reduced Labor Costs – No plugging, patching or sacking.
• Reusable Parts – Simply strip hardware from form, reuse over 100 times.
• Superior Finishes – Eliminates rust and corrosion. Strips flush to concrete.
• Variety of Colors – We offer colors to blend with the wall. Custom colors available.
• Reduced Inventory – One SuperTie™ fits any wall width.
• Electromagnetically Transparent – Ideal for situations where interference is undesirable.

SuperTie™ Coil Rod System offered in three different strengths: 15,000 pounds (7,500 pounds safe working load), 24,000 pounds (12,000 pounds safe working load at) and 34,000 pounds (17,000 pounds safe working load) and is most commonly used with job-built (plywood and 2×4) forms and handset modular forms. These specific Fiberglass Coil Rod ties will never rust, eliminating the need for break-back, plugging, and works well with anything from handset wall forms to crane-set gang-form systems.

• A Variety of Sizes – ½”, ¾”, and 1” diameters with strengths of up to 15,000, 24,000, and 34,000 lbs.
• Extends Form Life – All forms and form liners strip easily from the structure without damage from the ties saving money and time.
• Reusable Parts – Simply strip hardware from form, reuse over 100 times.

Always use 2:1 safety factor when engineering tie spacings; refer to the ACI-suggested tie spacing noted in the SuperTie Installation Guide.